Cylinder Block (I) Disassembly/Assembly

CYLINDER BLOCK (l) DISASSEMBLY/ASSEMBLY





1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.

Flywheel (MTX), Drive Plate (ATX) Disassembly Note





- Hold the crankshaft using the SST

Oil Pan Disassembly Note

Caution: Do not force a prying tool between the MBSP and the cylinder block which may damage the contact surfaces.





- Remove the oil pan using the separator tool.

Main Bearing Support Plate (MBSP) Disassembly Note





- Remove the MBSP using the separator tool.

Oil Pump Disassembly Note





- Remove the front oil seal using a screwdriver protected with a rag.

Rear Cover Disassembly Note





- Remove the rear oil seal using a screwdriver protected with a rag.

Rear Cover Assembly Note
1. Apply clean engine oil to the oil seal.
2. Push the oil seal slightly in by hand.





3. Press the oil seal in evenly using the SSTs.





4. Apply silicone sealant to the rear cover as shown.

Oil Pump Assembly Note
1. Apply clean engine oil to the oil seal.
2. Push the oil seal slightly in by hand.





3. Press the oil seal in evenly using the SST





4. Apply silicone sealant to the oil pump as shown.

MBSP Assembly Note





1. Apply silicone sealant to the oil pump and rear cover mounting surfaces of the new oil pan gaskets, and install them.





2. Apply silicone sealant to the MBSP as shown.

Oil Pan Assembly Note





- Apply silicone sealant to the oil pan as shown.

Flywheel (MTX), Drive Plate (ATX) Assembly Note
1. Hold the flywheel using the SST





2. Tighten the bolts a few turns in the order shown.

Water Pump Assembly Note





- Verify that the rubber seal is securely fixed onto the water pump.
- If not, remove the rubber seal and reinstall it with the bonding agent.