With Drum Brakes

WHEEL HUB, HUB SPINDLE (DRUM BRAKE TYPE) REMOVAL/INSTALLATION

Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.





1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.

Locknut Removal Note





1. Raise the staked portion of the locknut using a small cape chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.

ABS Sensor Rotor (With ABS) Removal Note

Note: The sensor rotor does not need to be removed unless it is being replaced.





1. Remove the sensor rotor using a chisel.

ABS Sensor Rotor (With ABS) Installation Note





1. Set the SST as shown in the figure.

Caution: Position the SST so that marking A faces the bottom.





2. Press on the new sensor rotor using the SST and a press.

Locknut Installation Note





1. Install a new locknut and stake it as shown.