Component Tests and General Diagnostics

VEHICLE SPEEDOMETER SENSOR (VSS) INSPECTION [ATX]
Visual Inspection
1. Remove the VSS.
2. Make sure that the sensor is free of any metallic shavings or particles.
^ If any are found on the sensor, clean them off.

3. Install the VSS.

Frequency Inspection Using the WDS or equivalent
1. Connect the WDS or equivalent.
2. Inspect frequency value and VSS PID.
^ If FREQUENCY value is out of specifications, perform the "Open or short circuit inspection" below and repair or replace parts as necessary.








Specifications

Power Supply Voltage Inspection
1. Disconnect the VSS connector.
2. Turn the ignition switch to ON.





3. Measure voltage at VSS connector terminal B (wiring harness side).
Specification 4.5 - 5.5 Volts
^ If voltage is okay, go to "See Open Circuit Inspection" and "Short Circuit Inspection".
^ If voltage is wrong, repair wiring harness between VSS and PCM.

Open Circuit Inspection
1. Inspect the following circuit for open.
^ Power circuit (VSS connector terminal A to main relay terminal D)
^ Ground circuit (VSS connector terminal C to GND)
^ If an open circuit or short circuit is found, repair the malfunctioning wiring harness.
^ If there are no open or short circuits, perform the sensor rotor inspection.

Short Circuit Inspection





1. Inspect the following circuit for short.
^ Power circuit (VSS connector terminal A to main relay terminal D)
^ If an open circuit or short circuit is found, repair the malfunctioning wiring harness.
^ If there are no open or short circuits, perform the sensor rotor inspection.

Sensor Rotor Inspection
1. Remove the VSS.
2. Shift the selector lever to N position.
3. Inspect sensor rotor surface via VSS installation hole while rotating the front tire manually.
1) Is sensor rotor free of damage and cracks?
2) Is sensor rotor free of any metallic shavings or particles?
^ If sensor rotor is okay, replace VSS.
^ If there is a problem, clean or replace the sensor rotor.