Transmission Speed Sensor: Service and Repair

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Disconnect the input/turbine speed sensor connector.





4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 69.9 - 95.4 inch lbs.)
7. Connect the input/turbine speed sensor connector.
8. Install the air cleaner component.
9. Connect the negative battery cable.