Removal and Installation

STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION

Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit In the harness If It Is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.





1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, inspect the toe-in.

Tie-rod End Ball Joint Removal Note
1. Remove the tie rod nut.





2. Separate the tie-rod end from the steering knuckle using the SSTs.

Engine Mount Member Removal Note





1. Set the SSTs as shown in the figure.
2. Remove the engine mount member.

Bolt (intermediate Shaft) Removal Note





1. Mark the pinion shaft and gear housing for proper installation.

Steering Gear and Linkage Removal Note
1. Remove the steering gear and linkage by pulling it from the right side.

Bolt (intermediate Shaft) Installation Note
1. Align the marks and install the intermediate shaft and bolt.