Trunk / Liftgate Latch Release Cable: Service and Repair

TRUNK LID LOCK REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.




2. Remove in the order indicated below.
1. Cover
2. Connector
3. Trunk lid lock
4. Trunk lid lock cylinder
5. Internal trunk lid release handle
6. Rod

3. Install in the reverse order of removal.

Internal Trunk Lid Release Handle Installation Note

CAUTION: Always keep the handle firmly attached to the holder and in the recessed position. Not securing the handle this way could allow it to snag luggage in the compartment and open the trunk lid.




1. After installation of the internal trunk lid release handle, pull the handle forward to verify the handle and rod are securely installed.
2. Attach the handle to the holder and in the recessed position.

TRUNK LID OPENER REMOVAL/INSTALLATION

1. To remove the trunk lid opener cable, perform the following.
1. Remove the driver's seat.
2. Remove the driver-side front and rear scuff plate.
3. Remove the driver-side B-pillar lower trim.
4. Remove the driver's seat belt lower anchor.
5. Remove the passenger's side tire house trim.
6. Remove the trunk end trim.
7. Turn the floor covering over.




2. Remove in the order indicated below.
1. Cover
2. Trunk lid opener lever
3. Trunk lid opener cable

3. Install in the reverse order of removal.
4. Adjust the trunk lid opener cable.