Transmission Position Sensor/Switch: Adjustments
TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and air cleaner component.
3. Remove the splash shield.
4. Remove the clip and disconnect the selector cable.
5. Rotate the manual shaft to the converter housing side fully, then return 2 notches to set the N position.
6. Disconnect the TR switch connector.
7. Loosen the TR switch mounting bolts.
8. Connect an ohmmeter between terminals B and H.
9. Adjust the switch to the point where there is continuity between the terminals.
10. Tighten the TR switch mounting bolts.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 69.5 - 95.4 inch lbs.)
11. Verify that the selector lever range position and TR switch are aligned.
12. Connect the TR switch connector.
13. Install the clip as shown in the figure.
14. Connect the selector cable.
15. Install the splash shield.
16. Install the air cleaner component and fresh-air duct.
17. Connect the negative battery cable.