Removal/Installation

FRONT BUMPER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Disconnect the front fog light connector.
3. To remove the bumper reinforcement, remove the front bumper and washer tank, then remove the bumper reinforcement installation nuts.




4. Remove in the order indicated below.
1. Screw A
2. Fastener
3. Screw B
4. Bolt
5. Front bumper
6. Front bumper reinforcement

5. Install in the reverse order of removal.
6. Adjust the front fog light aiming.

Front Bumper Removal Note




1. While supporting the connection between the front bumper and bracket, pull the front bumper forward to disengage the connection.

NOTE: The connection between the front bumper and bracket does not disengage until the front bumper is pulled forward. Be sure to pull the front bumper forward to disengage it from the bracket.

2. Remove the front bumper.

Front Bumper Installation Note




1. Spread the front bumper ends (wheel arches) apart.
2. Attach the front bumper to the body.
3. Press the front bumper connection portion into the body to engage with the bracket.