Driver-Side Air Bag Module

DRIVER-SIDE AIR BAG MODULE

WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the air bag module.

1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait tor more than 1 minute.




3. Remove in the order indicated in the table.
1. Bolt
2. Connector
3. Driver-side air bag module

4. Install in the reverse order of removal.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
- If the air bag system warning light does not operate in the manner described, there are malfunctions in the system. Inspect the system using the on-board diagnostic function. (See FOREWORD.)




Connector Installation Note
1. Install the connector as shown in the figure.