Body - Power Door Lock Malfunctions
09-012/01POWER DOOR LOCK MALFUNCTIONS
APPLICABLE MODEL(S)/VINS
All 1999-2001 Protege with VINs lower than JM1 BJ22**** ** 435184.
DESCRIPTION
The driver's door lock actuator of some vehicles may be susceptible to internal corrosion. This may cause the door lock actuators to lock and unlock by themselves.
Customers having this concern should have their vehicle repaired using the following procedure.
NOTE:
If the keyless entry remote was used to unlock the vehicle and the doors are not opened within 2 minutes, the doors will automatically relock.
REPAIR PROCEDURE
1. Verify customer concern.
2. Remove the driver's side door panel according to Workshop Manual (section 07-17 INTERIOR TRIM).
3. Gently peel back the plastic door screen near the lock area.
NOTE:
Avoid damaging the door screen which may result in water and air leaks. Use care when handling and reinstalling.
4. Inspect Lot Number on actuator and confirm that it was produced before December 11, 2000. (See illustration.)
NOTE:
Lock assembly removal is not required to view Lot Number.
^ If actuator production date is before December 11, 2000, then install a new power door lock actuator according to Workshop Manual (section 09-14 SECURITY AND LOCKS).
^ If actuator production date is after December 11, 2000, then continue diagnosis according to Workshop Manual (section 09-14 SECURITY AND LOCKS).
5. Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
NOTE:
This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term information.
Disclaimer