Operation CHARM: Car repair manuals for everyone.

Operation Mode

INSPECTION OF DTCS FOR OPERATION MODE

NOTE:
- If an Operation Mode is not indicated, the following may be the cause of the malfunction.
1. Cruise control switch (RESUME/ACCEL switch)
2. Cruise control main switch
3. Cruise control module
4. Open or short circuit in wiring harness

Using The Cruise Set Indicator Light
1. Turn the ignition switch to the ON position.
2. Verify that the cruise control main switch is off.




3. Perform the following steps to activate the operation mode.
1. Push up the cruise control switch and hold it in the RESUME/ACCEL position.
2. Turn on the cruise control main switch.
3. Hold the cruise control switch in the RESUME/ACCEL position for at least 3 seconds. (The cruise set indicator light will illuminate for 3 seconds.)

4. Operate each switch as described in the operation code list and note the operation code list pattern.
- If the cruise set indicator light does not flash, inspect the corresponding system area.

5. The operation mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.