Radio, Stereo, and Compact Disc: Service and Repair
AUDIO UNIT REMOVAL1. Disconnect the negative battery cable.
2. Remove the service hole covers by inserting a small tape-wrapped flathead screwdriver into the slot and carefully try them off without scratching the center panel. Pry up and pull off the service hole covers carefully to prevent the posts fro breaking off.
NOTE: Two sets of the SSTs (Removing tool) are necessary to remove the audio unit.
3. With the beveled parts of the SST (Removing tool) facing inward, insert them into the audio unit.
4. Pull the SST (Removing tool) outward and rearward to slide out the audio unit.
5. Disconnect the audio unit connectors and antenna jacks.
AUDIO UNIT INSTALLATION
CAUTION: Make certain that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the harness or the antenna feeder is caught between the unit and dashboard, it may become the cause of trouble or malfunctions.
1. Install the audio unit service hole covers.
2. Connect the audio unit connectors and antenna jacks.
3. Insert the audio unit until each clip clicks.
4. Connect the negative battery cable.
UPPER MODULE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the audio unit.
3. Remove in the order indicated below.
1. Screw
(See Screw Installation Note)
2. Upper module
(See Upper Module Removal Note)
3. Cover
(See Cover Removal Note)
4. Install in the order of removal.
Upper Module Removal Note
1. Insert a screwdriver into the hole stamped mark.
2. To remove upper module, lift it by pushing down the screwdriver's handle.
Cover Removal Note
1. Insert a tape-wrapped screwdriver between the cover and the base unit, then unhook the hook A.
2. To unhook the hook B, pull the cover upward.
Screw Installation Note
CAUTION: If an undesignated screw is used, the inside of the upper module could be damaged. When installing the module, be sure to use designated screw (red).
LOWER MODULE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the audio unit.
3. Remove in the order indicated below.
1. Cover
(See Cover Removal Note)
2. Screw
(See Screw Installation Note)
3. Lower module
4. Install in the order of removal.
Cover Removal Note
1. Insert the SST into the service holes on the bottom surface of the lower module.
2. To remove the cover, push the SST in the direction shown by the arrow.
Screw Installation Note
CAUTION: If an undesignated screw is used, the inside of the upper module could be damaged. When installing the module, be sure to use a designated screw (red).