Rearview Mirror

REARVIEW MIRROR REMOVAL




1. Insert a flathead screwdriver between the mirror and the base.
2. Push the base pin to remove the rearview mirror.

REARVIEW MIRROR INSTALLATION




1. Install the rearview mirror onto the base.

BASE REMOVAL




1. Remove the rearview mirror.
2. Wind each end of the SST (piano wire) around a bar.

WARNING: Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using the SST (piano wire).

NOTE: Use the entire length of the SST (piano wire) to prevent it from breaking when cutting through the sealant.

3. Saw through the sealant to remove the base.

BASE INSTALLATION

WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.

CAUTION: Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass.




3. Apply primer to the bonding area of the glass and the base.
4. Apply a height of 3.0 mm {0.12 in} sealant to the base.

NOTE: Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approximately 30 minutes.

5. Center the base in the ceramic coating and press it onto the glass.







6. Use isopropyl alcohol to remove any excess sealant.
7. Install the rearview mirror.