Operation Mode
INSPECTION OF DTCS FOR OPERATION MODENOTE:
- If an Operation Mode is not indicated, the following may be the cause of the malfunction.
1. Cruise control switch (RESUME/ACCEL switch)
2. Cruise control main switch
3. Cruise control module
4. Open or short circuit in wiring harness
Using the Cruise Set Indicator Light
1. Turn the ignition switch to ON position.
2. Verify that the cruise control main switch is off.
3. Turn and hold the RESUME/ACCEL switch on then turn on the cruise control main switch to activate system inspection. (The cruise set indicator light will illuminate for 3 seconds.)
4. Operate each switch as described in the operation code list and note the operation code list pattern.
- If the cruise set indicator light does not flash, inspect the corresponding system area.
5. The operation mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.
Using The SST (WDS or equivalent) DTCs retrieving procedure
1. Hook-up the SST to the vehicle. Make sure that ignition key is at LOCK and all accessories are OFF.
2. Turn the ignition key to ON (engine OFF).
3. Retrieve any DTCs by WDS or equivalent.