Y16M-D

MANUAL TRANSMISSION REMOVAL/INSTALLATION [Y16M-D]





1. Drain the transmission oil.
2. Remove the cross member. (16-inch wheel vehicles)
3. Remove the cross member bracket. (16-inch wheel vehicles)
4. Remove the rear crossbar. (16-inch wheel vehicles)
5. Remove the undercover.
6. Remove the starter.
7. Remove the front pipe and middle pipe.
8. Remove in the order indicated in the table.
9. Install in the reverse order of removal.
10. Add the specified amount and type of transmission oil.
11. Warm up the engine and transmission, inspect for oil leakage, and verify the transmission operation.