Radio, Stereo, and Compact Disc: Application and ID

SUPPLIER IDENTIFICATION PROCEDURE

NOTE: When asking the supplier (service center) for repair or replace, verify which supplier the module belongs to and enter in the Audio Exchange Order Form. (See Warranty Bulletin Category AD, number 32.) Use the table and illustration below to determine the audio supplier.

Identification With Printed Numbers/label

Base unit




1. To get the supplier name, compare the leftmost number of the ID code (4 digits), printed on the upper right corner of the LCD, with the table.

Upper/lower module

1. Remove the audio unit.
2. Verify the supplier name written in the label attached on each module.

Identification With On-board Diagnostic Test Mode

1. Start the on-board diagnostic test mode.







2. Verify the device code and supplier code displayed in the LCD.

NOTE: When no DTCs are in the memory, device code and supplier codes will not be displayed.