Roof Molding

ROOF MOLDING REMOVAL/INSTALLATION




1. Remove as indicated in the table.
2. Install in the reverse order of removal.

Roof Molding Installation Note

1. If a clip is damaged, replace it as follows:
1. Mark the position of the clip and then remove it.
2. Remove any adhesive remaining on the body.




3. Peel off the double-sided tape protectors and align the new clip with the mark made in step (1).




4. Apply primer to the shaded area as indicated in the table the figure and allow it to dry for approximately 30 minutes. Keep the area free of dirt and grease, and do not touch the surface.

Hardening Time Of Sealant:

5. Apply a bead of sealant as shown.
- If necessary, shape the sealant with a spatula.




2. Align the rear end of the molding with the body and press down firmly on the molding.




3. After installing the molding, inspect for gaps between the body and the molding and between the glass and the molding.
- If there is a gap, secure the molding with adhesive tape until the sealant hardens.