Power Door Lock Control Module: Service and Repair

DOOR LOCK CONTROL MODULE REMOVAL/INSTALLATION

NOTE: Because the lock section of the relay is damaged easily, do not remove the module from the bracket unless replacement is necessary. Always perform an inspection of the module before removal.

1. Disconnect the negative battery cable.
2. Remove the rear seat back.




3. Remove the bracket.
4. Disconnect the door lock control module connector.
5. Remove the door lock control module by prying the lock section of the upper pan with a flathead screwdriver.
6. Install in the reverse order of removal.

DOOR LOCK CONTROL MODULE INSPECTION

1. Disconnect the door lock control module connector.







2. Inspect for continuity between the terminals of the door lock control module connector.
3. Reconnect the door lock control module connector.




4. Measure the voltage at the terminals of the door lock control module connector with the following terminals connected to GND.
- If not as specified, replace the door lock control module.