Floor Covering

FLOOR COVERING REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the front seats.
3. Remove the rear seat cushion.
4. Remove the tire house trim.
5. Remove the dashboard.
6. Remove the front side trim.
7. Remove the B-pillar lower trim.
8. Remove the lower anchor of the front seat belt installation bolts.
9. Remove the selector cable if equipped with ATX. (See SELECTOR LEVER REMOVAL/INSTALLATION.)
10. Remove the interlock cable it equipped with ATX. (See SELECTOR LEVER REMOVAL/INSTALLATION.)
11. Remove the rear heat duct.




12. Remove the fasteners and clips A, then remove the floor covering.
13. Remove the floor covering from the vehicle through the passenger-side front door.
14. Install in the reverse order of removal.