Rear Door Trim

REAR DOOR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable if equipped with power window.
2. Remove the regulator handle it equipped.




3. Insert a tape-wrapped fastener remover under the pull-handle cover, and disengage tab A.




4. Insert a tape-wrapped flathead screwdriver into the access hole under the forward pull-handle cover, and remove the pull-handle cover by pulling it upward and diagonally while pushing clip B.




5. Remove the screws and fasteners.
6. Disengage clips C using a fastener remover.
7. Pull the rear door trim upward, then disengage pins D from the body.
8. Disconnect the power window sub switch connector if equipped.
9. Remove the inner handle from the rear door trim.
10. Install in the reverse order of removal.