Alarm Module: Testing and Inspection

THEFT-DETERRENT CONTROL MODULE INSPECTION

1. Remove the theft-deterrent control module without disconnecting the connector.
2. Measure the voltage at the theft-deterrent control module terminals as indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals B, N, O, P, and T.
4. If not as specified, inspect the parts listed under "Action."
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the theft-deterrent control module.

Terminal Voltage Table (Reference) - (Terminal A - G):

Terminal Voltage Table (Reference) - (Terminal H - V):

Terminal Voltage Table (Reference) - (Terminal W - X):

Terminal Voltage Table (Reference)