Operation CHARM: Car repair manuals for everyone.

Steering: Service Precautions

PRECAUTION (STEERING)
Wheels and Tires Removal/Installation
1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88 - 118 Nm (9.0 - 12.0 kgf-cm, 65.0 - 87.0 ft. lbs.).

Power Steering Components Removal/Installation
1. If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III, M-V or equivalent (e.g. Dexron III), bleed the fluid lines, and inspect for leakage after the procedure has been completed.

Electric Connectors Disconnection/Connection
1. Disconnect the negative battery cable before doing any work that requires handling of electric connectors. Reconnect the negative battery cable only after the work is completed.

Suspension Arm Removal/Installation
1. Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered to the ground and unloaded.

Note:
^ Unloaded: Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack, and tools are in designated position.