Transaxle Range (TR) Switch Inspection

TRANSAXLE RANGE (TR) SWITCH INSPECTION

Note:
^ Input signals of the TR switch can be inspected with a WDS or equivalent.

Inspection of Operation
1. Verify that the starter operates only with the ignition switch at the START position and the selector lever in P and N positions.
^ If not as specified, inspect for continuity at the TR switch.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch at the ON position.
^ If not as specified, inspect for continuity at the TR switch.

Inspection of Continuity
1. Disconnect the negative battery cable.
2. Disconnect the TR switch connector.








3. Inspect for continuity at the TR switch.
^ If not as specified, adjust the TR switch, then reinspect the TR switch.





4. Connect the TR switch connector.
5. Connect the negative battery cable.