Vehicle Speedometer Sensor (VSS) Inspection
VEHICLE SPEEDOMETER SENSOR (VSS) INSPECTIONOn-Vehicle Inspection
1. Disconnect the negative battery cable.
2. Disconnect the terminal component No.2 connector.
3. Measure resistance between terminals A and B.
^ If not as specified, inspect individual part.
Resistance (ATF temperature: 20°C (68°F)) 513 - 627 ohms
4. Connect the terminal component No.2 connector.
Inspection of Individual Part
1. Remove the VSS sensor.
2. Measure resistance between the terminals of the VSS speed sensor.
^ If not as specified, replace the VSS sensor.
^ If it is normal, replace the harness.
Resistance (ATF temperature: 20°C (68°F)) 513 - 627 ohms
3. Install the VSS sensor.