Clutch Unit Removal & Installation
CLUTCH UNIT REMOVAL/INSTALLATION1. Remove in the order indicated in the table.
2. Install in the reverse order removal.
A65M-R manual transaxle models
1. Install the clutch aligner and the SST.
2. Loosen each bolt one turn at a time in a criss-cross pattern until spring tension is released.
3. Remove the clutch cover and disc.
Flywheel Removal Note
1. Hold the flywheel using the SST.
2. Remove the bolts evenly and gradually in a criss-cross pattern.
3. Remove the flywheel.
Flywheel Installation Note
1. Install the flywheel to the crankshaft.
2. When reusing the bolts, clean threads and hole, then apply locking compound to the threads.
Note:
^ No locking compound is needed when using new bolts.
3. Hand-tighten the flywheel lock bolts.
4. Install the SST to the flywheel.
5. Gradually tighten the flywheel lock bolts in a crisscross pattern.
Tightening torque
A65M-R manual transaxle models 73 - 87 Nm (7.5 - 8.8 kgf-cm, 54 - 64 ft. lbs.)
A65M-R manual transaxle models
1. Hold the clutch disc position using the clutch aligner.
A65M-R manual transaxle models
1. Install the clutch aligner and the SST
2. Tighten the bolts evenly and gradually in a crisscross pattern.
Tightening torque 25 - 33 Nm (2.6 - 0.3 kgf-cm, 19 - 24 ft. lbs.)