Oil Pump: Service and Repair
OIL PUMP REMOVAL/INSTALLATION1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Remove the oil pan.
4. Remove the timing chain.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Start the engine and inspect for oil leakage.
- If the oil leaks, specified the faulty part and repair or replace it.
8. Inspect the oil level.
9. Inspect the oil pressure.
Oil Pump Removal Note
1. Loosen the oil pump bolts in the order shown.
Oil Pump Installation Note
1. Tighten the oil pump bolts in the order shown.
Oil Strainer Installation Note
1. Tighten the oil strainer bolts.
Tightening torque 8 - 12 Nm (82 - 122 kgf-cm, 71 - 106 inch lbs.)
2. Tighten the oil strainer stay nut to 15.0 Nm (153 kgf-cm, 133 inch lbs.), then tighten it further 45° using the SST.