Programming and Relearning

PCM CONFIGURATION




1. Connect the WDS to the DLC-2.
2. Set up the WDS (including the vehicle recognition).
3. Select "Module Programming".
4. Select "Programmable Module Installation".
5. Select "PCM" and perform procedures according to directions on the WDS screen.

NOTE:
- If the PCM is replaced with a new one, the PCM stores DTC P0602 and illuminates the MIL even though no malfunction is detected. After completing the "PCM CONFIGURATION" procedure, clear DTC P0602 using the WDS or equivalent.
- MIL goes off after three drive cycles with no failure. (DTCs remain in PCM.)

6. Retrieve DTCs with the WDS or equivalent, then verify that there in no DTC present.
- If DTC is present, perform applicable DTC inspection.