Power Door Lock Control Module: Testing and Inspection

DOOR LOCK CONTROL MODULE INSPECTION

1. Measure the voltage at the door lock control module terminals (other than terminals 1E, 2G, 2K and 2W) as indicated below.
- If not as specified, inspect the parts listed under "Action."

2. Disconnect the negative battery cable.
3. Disconnect the door lock control module connector and inspect for continuity between terminal 1E or 2W and the bracket.
4. Inspect for continuity at terminals 1 E, 2G, 2K and 2W as indicated below.
5. If the parts and wiring harnesses are okay but the system still does not work properly, perform the troubleshooting.

Terminal 1A - 1E:

Terminal 1F - 2L:

Terminal 2M - 2X:

Terminal voltage list (Reference)