Clutch Operation
Clutch Operation1. Set the reverse clutch and high clutch component onto the end cover.
Warning: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.
Caution: Applying compressed air to the assembled clutch pack for longer than 3 seconds at a time will damage the seal. Do not apply compressed air for more than the aforementioned time when testing the system.
Note: Regarding the position of the hole into which air is blown, refer to item "Oil pressure circuit".
2. Inspect the clutch operation by applying compressed air through the fluid passages shown.
^ If not as specified, replace parts where necessary.
Air pressure:
390 kPa (4.0 kgf-cm2, 57 psi) max.