Intermediate Sensor Inspection

INTERMEDIATE SENSOR INSPECTION [JA5A-EL]
On-Vehicle Inspection





1. Disconnect the negative battery cable.
2. Disconnect the terminal component No.2 connector.





3. Measure resistance between terminals C and D.
^ If not as specified, inspect individual part.
Resistance (ATF temperature: 20°C (68°F)) 513 - 627 ohms
4. Connect the terminal component No.2 connector.

Inspection of Individual Part
1. Remove the intermediate sensor.





2. Measure resistance between the terminals of the intermediate speed sensor.
^ If not as specified, replace the intermediate sensor.
^ If it is normal, replace the harness.
Resistance (ATF temperature: 20°C (68°F)) 513 - 627 ohms
3. Install the intermediate sensor.