Rotor Disassembly Note

Rotor Disassembly Note





Note
^ Pair each seal and spring according to the numbers shown in the figure, and place them in the SST according to the numbers shown on the SST.





1. Remove the side piece, apex seal, corner seal, side seal, and spring on the engine rear side, and place them in the SST while keeping them in order.





2. Move the rotor to the left and right to cut the oil film.
3. Remove the rotor.

Caution
^ If a seal adheres to the side housing, put it back in its original position in the rotor.
^ Place the removed rotor upright on soft material such as a rubber sheet or cloth. Do not allow the oil seal to directly contact metal are similar hard surface.





4. Remove the corner seal, side seal, and spring on the engine front side, and place them in the SST while keeping them in order.