Vehicle Speed Sensor: Service and Repair
VEHICLE SPEED SENSOR (VSS) REMOVAL/INSTALLATIONCaution:
^ Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not enter the connector when disconnecting it.
^ If foreign material is stuck to the VSS, disturbance by magnetic flux can cause sensor output to be abnormal and there by negatively affect control. Make sure that foreign material such as iron particles is not stuck to the VSS during installation.
1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the catalytic converter.
5. Remove the insulator.
6. Disconnect the TR switch connector.
7. Disconnect the VSS connector.
8. Remove the VSS.
9. Apply ATF to a new O-ring and install it on a VSS.
10. Install the VSS.
Tightening torque 5.0 - 7.0 Nm (51 - 71 kgf-cm, 43 - 61 inch lbs.)
11. Connect the VSS connector.
12. Install the insulator.
Tightening torque 8 - 11 Nm (82 - 112 kgf-cm, 72 - 97 inch lbs.)
13. Install the catalytic converter.
14. Connect the negative battery cable.
15. Install the battery cover.
16. Install the engine cover.