Cylinder Block (II) Assembly

CYLINDER BLOCK (II) ASSEMBLY





1. Assemble in the order indicated in the table.

Rear Oil Seal Assembly Note





1. Apply silicone sealant to the mating faces as shown in the figure.
Thickness 4.0 - 6.0 mm {0.16 - 0.23 inch}
2. Apply clean engine oil to the new oil seal lip.





3. Install the rear oil seal using the jig as shown in the figure.





4. Tighten the rear oil seal bolts in the order as shown in the figure.
Tightening torque 8.0 - 11.5 Nm {81.6 - 117.2 kgf-cm, 70.9 - 101.7 inch lbs.)

Drive Plate (ATX), Flywheel (MTX) Assembly Note
1. Hold the crankshaft using the SST.





2. Tighten the bolts in the 3 steps in the figure.
Tightening torque
1 46 - 54 Nm {4.70 - 5.50 kgf-m, 34.0 - 39.8 ft. lbs.}
2 76 - 84 Nm {7.75 - 8.56 kgf-m, 56.1 - 61.9 ft. lbs.}
3 108 - 116 Nm {11.1 - 11.8 kgf-m, 79.7 - 85.5 ft. lbs.}

Oil pan Assembly Note





1. Apply a continuous bead of silicone sealant to the oil pan as indicated in the figure.

Caution
- Install the oil pan within 10min of applying the silicone sealant
- Make sure that there is no oil or dust on the seal side of oil pan.





2. Use a square ruler to unite the oil pan and the cylinder block junction side on the engine front cover side.





3. Tighten the rear oil pan bolts in the order as shown in the figure.
Tightening torque 17 - 23 Nm {1.8 - 2.3 kgf-m, 12.6 - 16.9 ft. lbs.}