Operation CHARM: Car repair manuals for everyone.

Variable Tumble Solenoid Valve Inspection

VARIABLE TUMBLE SOLENOID VALVE INSPECTION

1. Remove the variable tumble solenoid valve.







2. Inspect airflow between the ports under the following conditions.
- If not as specified, replace the variable tumble solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".

Circuit Open/Short Inspection




1. Disconnect the PCM connector.
2. Inspect the following wiring harness for open or short (continuity check).

Open circuit
- If there is no continuity, the circuit is open. Repair or replace the wiring harness.
- Variable tumble solenoid valve terminal B and PCM terminal 2AI
- Variable tumble solenoid valve terminal A and main relay terminal A

Short circuit
- If there is continuity, the circuit is shorted. Repair or replace the wiring harness.
- Variable tumble solenoid valve terminal A and body GND
- Variable tumble solenoid valve terminal B and power supply