Rear Door Trim

REAR DOOR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.




2. Open the cap using a small screwdriver, then remove the screw.
3. Remove the inner handle cover.
4. Remove the cover, then remove screw A.
5. Disengage clips A from the rear door using a fastener remover.




6. Pull the rear door trim upward, then disengage tabs B from the rear door.
7. Disconnect the power window subswitch connector.
8. Remove the rear door trim.
9. Remove the switch panel from the rear door trim.
10. Install in the reverse order of removal.