Fluid Pressure Sensor/Switch: Service and Repair

OIL-PRESSURE SWITCH REMOVAL/INSTALLATION [FN4A-EL]

Warning:
^ A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before changing the ATF.

1. Disconnect the negative battery cable.
2. Remove the under cover.





3. Disconnect the cord assembly connector.
4. Remove the oil pressure switch.
5. Install the oil pressure switch.
Tightening torque 17.1 - 22.1 Nm (1.8 - 2.2 kgf-m, 12.7 - 16.2 ft. lbs.)
6. Connect the oil pressure switch connector.
7. Install the undercover.
8. Connect the negative battery cable.