Low Clutch Assembly

Assembly Procedure





1. Apply a coat of ATF to new seal ring and new O-ring, then install them onto piston.
2. Apply a coat of ATF to inside of the drum, then install the piston while rotating it by hand.

Note: After installing required parts to the piston, ensure that the piston rotates smoothly by hand. If not, the lip seal may be caught.

3. Apply a coat of ATF to a new O-ring then install it to the cancel force cover.
4. Position the return spring and cancel force cover.

Caution: Depress the spring retainer only enough to remove the snap ring. Overpressing will damage the retainer component edges.





5. Install the SSTs in the clutch drum as shown.
6. Install the snap ring.
7. Remove the SSTs.





8. Install the dished plate, drive plates, and driven plates in the order as shown in the figure.
9. Install the retaining plate.
10. Install the snap ring.