Reduction Gear Bearing Preload

REDUCTION GEAR BEARING PRELOAD





1. Set the reduction gear component on the two blocks as shown in the figure.

Note: To measure accurately, place only the idle gear on the blocks and do not allow the reduction gear component rotation part to contact the blocks.





2. Holding the idle gear by hand, verify that the preload scale reading is within the specification.
^ If not as specified, replace the reduction gear component.

Preload:
0.6-1.75 Nm (6.1-17.8 kgf-cm, 5.3-15.5 in. lbf.)