Condition Detection Mode
INSPECTION OF DTCS FOR CONDITION DETECTION MODEUsing the Cruise Set Indicator Light
NOTE: If the RESUME/ACCEL switch or the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. Use the SST (WDS or equivalent) to determine the cause of the malfunction.
1. Drive the vehicle at over 16 km/h {1O mile/h}.
2. Operate each of the cruise control switches.
3. Stop the vehicle and let it idle.
4. Turn on the cruise control main switch.
5. Turn and hold the RESUME/ACCEL switch on for at lea8t 3 seconds. The cruise set indicator light will illuminate for 3 seconds, and then go off for at least 2 seconds. Thus, the condition detection mode begins.
- If a diagnostic trouble code is indicated, inspect the corresponding system area.
6. The condition detection mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.
Using The SST (WDS or equivalent) DTCs retrieving procedure
1. Hook-up the SST to the vehicle. Make sure that ignition key is at LOCK and all accessories are OFF.
2. Turn the ignition key to ON (engine OFF).
3. Retrieve any DTCs by WDS or equivalent.
DTC 01 - 15:
Condition Code List
NOTE: When two or more service codes are indicated, inspect the malfunction with the smallest number first.