Rear Drain Hose
REAR DRAIN HOSE REMOVAL1. Remove the following parts:
1. Roof side trim.
2. A-pillar trim.
3. Rear seat.
4. Inner scuff plate.
5. Tire house trim.
6. Rear pillar trim.
7. Map light.
8. Interior light.
9. Sunvisor.
10. Assist handle.
11. Headliner.
12. Trunk end trim.
13. Trunk side trim.
2. Remove the sunroof frame from the rear drain hose.
3. Remove the rear drain hose from the clips.
4. Pull the rear drain hose into the vehicle interior and remove the rear drain hose.
REAR DRAIN HOSE INSTALLATION
CAUTION: If the rear drain hose is pinched or bent at any point, the water in the hose may not drain and could leak inside the vehicle. During and after installation of the trims and headliner, always make sure there is no interference with the rear drain hose. Correct any abnormality if found.
1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:
1. Trunk side trim.
2. Trunk end trim.
3. Headliner.
4. Assist handle.
5. Sunvisor.
6. Interior light.
7. Map light.
8. Rear pillar trim.
9. Tire house trim.
10. inner scuff plate.
11. Rear seat.
12. -pillar trim.
13. Roof side trim.