DSC HU/CM Removal/Installation
DSC HU/CM REMOVAL/INSTALLATIONCaution:
^ When replacing the DSC HU/CM with a new one, configuration procedure must be performed before removing the DSC HU/CM. If configuration is not completed before removing the DSC HU/CM, DTC B2477 will be detected.
^ The DSC may not function normally when the DSC HU/CM is replaced. After installation, always perform the initialization procedures for the combined sensor and the steering angle sensor.
^ The internal parts of the DSC HU/CM could be damaged if dropped. Be careful not to drop the DSC HU/CM. Replace the DSC HU/CM if it is subjected to an impact.
1. Perform DSC configuration.
2. Remove the front suspension tower bar.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Connector Removal Note
1. Rotate the lock lever in the direction of the arrow, and remove the DSC HU/CM connector.
DSC HU/CM Removal/Installation Note
1. When removing/installing the DSC HU/CM from/to the vehicle, attach a strip of protective tape on the DSC HU/ CM connector to prevent brake fluid from entering.
Connector Installation Note
1. After connecting the connector, rotate the lock lever in the direction of the arrow to install the DSC HU/CM connector.