[Manual Air Conditioner]

CLIMATE CONTROL UNIT REMOVAL[MANUAL AIR CONDITIONER]
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Ashtray panel
2. Detach the hood release lever from the lower panel.
3. Front scuff plate
4. Front side trim
5. Lower panel
6. Decoration panel
7. Glove compartment
8. PJB and PJB bracket
9. Console

3. Detach the PJB wiring harness clamp from the dashboard.
4. Remove the center panel module.




5. Remove the wire clamp screws from the A/C unit at the positions shown in the figure.




6. Remove the air mix wire and airflow mode wire.
1. Pull the wire in the direction shown by the arrow and remove it while pressing the link tab.




7. Release the left and right tabs and remove in the order indicated in the table.




8. Remove the E-rings from the air mix wire and airflow mode wire, slide the wires in the direction shown by the arrow, then remove the wire clamps from the air mix wire and airflow mode wire.

CLIMATE CONTROL UNIT INSTALLATION[MANUAL AIR CONDITIONER]
1. Install the wire clamp to the A/C unit.
2. Set the temperature control dial at MAX COLD.
3. Set the airflow mode selector dial at defroster.




4. Install the E-rings to each position on the wires shown in the figure.




5. Pass each wire through the following routes and connect to A/C unit.
6. Connect the climate control unit connectors.
7. Install the climate control unit.
8. Adjust the climate control unit wires.
9. Install the center panel module.
10. Attach the PJB wiring harness clamp to dashboard.
11. Install the following parts.
1. Console
2. PJB and PJB bracket.
3. Glove compartment
4. Decoration panel
5. Front side trim
6. Front side trim
7. Front scuff plate
8. Detach the hood release lever from the lower panel.
9. Ashtray panel

12. Connect the negative battery cable.