Steering Angle Adjustment
Steering Angle Adjustment1. Loosen the locknut of the tie-rod end.
2. Remove the rack boot clamp.
3. Rotate the tie rod and adjust the steering angle.
Note: The travel distance of the right and left tie rods should be the same.
4. Rotate the tie rod and adjust so that the difference between right and left dimension L shown in the figure is less than the specification.
Standard 3 mm (0.12 in) or less
5. Tighten the locknut of the tie-rod end.
Tightening torque 78.6 - 108.0 N-m (8.02 - 11.01 kgf-m, 57.98 - 79.65 ft-lbf)
6. Correct the rack boot twists.
7. Install and fix the rack boot clamp.
8. After adjusting the steering angle, always inspect and adjust the toe angle.