Programming and Relearning

BRAKE FLUID PRESSURE SENSOR INITIALIZATION PROCEDURE

Warning: If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.

1. Turn the ignition switch off.
2. Connect the M-MDS to the DLC-2.





3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
^ When using the IDS (laptop PC)
1. Select "Chassis".
2. Select "ABS/DSC".
3. Select "Sensor Initialization".
^ When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "ABS".
3. Select "DataLogger".
4. Select "MCYL_S_CAL".
4. Perform the initialization procedure according to the directions on the screen.
5. Drive the vehicle.
6. After 5 min or more of driving, verify that the DSC system is normal.