Rear Knuckle: Service and Repair

WHEEL HUB COMPONENT REMOVAL/INSTALLATION

Caution: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (wheel hub side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.

1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.





Brake Caliper Component Removal Note
1. Remove the brake caliper component from the trailing link and suspend it out of the way using a cable.

Wheel Hub Bolt Removal Note

Note: The hub bolts do not need to be removed unless they are being replaced.





1. Remove the hub bolt using a press.

Wheel Hub Bolt Installation Note





1. Install the new hub bolt using a press.