Interior - Carpet Design Change
TSB: 09-032/07MAZDA3/MAZDASPEED3 - FLOOR COVERING (CARPET) CHANGED
APPLICABLE MODEL(S)/VINS
2004-2007 Mazda3/Mazdaspeed3 vehicles with
VINS lower than JM1 BK**** ** 696694 (produced before January 8, 2007)
DESCRIPTION
The floor covering (for mass production and service) has been changed since January 8, 2007, and there is no interchangeability between before and after the change.
1. When the floor covering has to be replaced on vehicles built prior to January 8, 2007, floor insulators will need to be ordered with the floor covering.
2. For vehicles originally fitted with former pads (BN8F680C1/0C2), do not fit them with these pads any more. If these vehicles need the former pads, use the new floor covering and floor insulators as mentioned above.
3. To attach the floor insulators, peel off the adhesive backing from the double-sided tape on the floor insulator and attach it to the floor covering approximately 10 mm inward from the corner of console side and the No. 2 cross member side.
NOTE:
Make sure there is 10 mm if clearance between the floor insulator and the corners of the floor covering.
PART(S) INFORMATION
Disclaimer