2007-2009 CX-7
2007-2009 CX-71. Dry the evaporator using the following procedure:
WARNING:
Running the engine inside an enclosed area, such as a garage, is dangerous. Exhaust gas, which contains poisonous carbon monoxide, could easily enter the cabin. Loss of consciousness or even death could occur. Don't run the engine when inside an enclosed area.
A. Start the engine.
B. Set the HVAC controls as follows.
^ RECIRCULATE
^ FULL HEAT
^ FAN HIGH
^ A/C OFF
^ AIRFLOW (FACE)
C. Open one window approximately one half inch.
D. Let the engine run for 15 minutes.
2. Remove the glove box by:
A. Pressing the damper stay in the direction shown by the arrow and detach it from the glove compartment lid.
B. Bending the stoppers inward to remove.
C. Turn the glove compartment downward and pull the pins.
3. Stop the engine. Switch OFF the fan motor.
4. Remove the cabin air filter cover, then the filter.
5. Shake a bottle of the Mazda Air Cooling Coil Coating well and attach it to the applicator, then connect the applicator to compressed shop air.
6. Insert the applicator through the the cabin air filter opening, then into the blower motor air intake opening. Point the nozzle tip downward and outward, and place it along the edge of the blower motor air intake opening.
7. Switch the fan motor ON.
8. Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF around the outer edge and into the rotating fan. A fine mist may exit from the ducts.
9. When the bottle is empty, switch the fan motor off, then remove the applicator.
NOTE:
For reuse, clean the applicator by flushing a bottle of clean water through it.
10. Reinstall the cabin air filter.
11. Reinstall the glove box.
12. Use STEP 1 to dry and cure the product.
13. Note application date in service record.