Repair Procedure

REPAIR PROCEDURE

1. Verify customer concern.

2. Turn ignition switch to "ON" position and press "OPEN" to open navigation system display.

3. Select "Agree" and press "ENTER".

NOTE:
Normally the current position screen appears, but the navigation system may exhibit one of the following failures depending on symptom(s).

- Displays NO MAP in screen (white or blue). Proceed to "A. NAVIGATION SYSTEM DISPLAYS NO MAP".

- Displays map, but does not display "the vehicle's current position". Proceed to "B. NAVIGATION SYSTEM DISPLAYS MAP, BUT DOES NOT DISPLAY VEHICLES CURRENT POSITION".

A. NAVIGATION SYSTEM DISPLAYS NO MAP

1. Move vehicle outside to open area away from buildings or high walls where GPS is receivable.

2. Stop vehicle in a safe location, set parking brake, and ensure all doors are closed.

NOTE:
Closing all doors prevents RF interference between navigation system and advanced keyless entry system.

3. With engine running, operate navigation for vehicle current position" following steps a - m:

a. Press "Menu Key".

b. Select "Destination Entry".

c. Press "Change".

d. Select AREA (vehicle current position), press "OK".

e. Select "Address".

f. Input address of vehicles current location.

g. Display current location.

h. Press "Menu" and select "Navigation Set Up".

I. Select "Calibration".

j. Select "Position/Direction".

k. Press "Enter".

I. Press "OK".

m. Display MAP.

4. Wait for a maximum of 20 minutes with engine running and all doors closed.

5. Procedure is complete when "GPS" appears on screen.

B. NAVIGATION SYSTEM DISPLAYS MAP BUT DOES NOT DISPLAY VEHICLES CURRENT LOCATION

1. Move vehicle outside to open area away from buildings or high walls where GPS is receivable.

2. Stop vehicle in a safe location, set parking brake, and ensure all doors are closed.

NOTE:
Closing all doors prevents RF interference between navigation system and advanced keyless entry system.

3. With engine running, operate navigation for vehicle current position" following steps a - i: