Initial Inspection and Diagnostic Overview

BCM SELF-TEST




1. Connect the WDS or equivalent to the DLC-2.
2. Set up the WDS or equivalent (including the vehicle recognition).
3. Verify the following vehicle conditions:
- Ignition switch is at ON position.
- All the switches are turned off (except the ignition switch).
- All the doors, hood, and liftgate are closed.
- All the doors, and liftgate are unlocked.
- Parking brake lever is pulled.

4. Perform procedures according to directions on the WDS or equivalent screen.
5. Verify if any DTCs are displayed.
- If any DTCs are displayed, perform the troubleshooting according to the corresponding DTC inspection.

6. Disconnect the WDS or equivalent.