Rear Drain Hose

REMOVAL




1. Remove the following parts:
1. A-pillar trim
2. Front scuff plate inner
3. Rear scuff plate
4. B-pillar lower trim
5. Front seat belt upper anchor installation bolt
6. B-pillar upper trim
7. Rear package tray lid
8. Sub-trunk
9. Third-row seat
10. Trunk end trim
11. Rear header trim
12. Third-row seat belt lower anchor installation bolt
13. Cargo compartment light
14. Trunk side trim
15. Second-row seat belt upper anchor installation bolt
16. C-pillar trim
17. Map light
18. Sunvisor
19. Assist handle
20. headliner

2. Disconnect the rear drain hose from the sunroof frame.
3. Remove the rear drain hose from the clips.
4. Pull the rear drain hose into the vehicle interior and remove the rear drain hose.

INSTALLATION

CAUTION: If the rear drain hose is pinched or bent at any point, the water in the hose may not drain and could leak inside the vehicle. During and after installation of the trims and headliner, always make sure there is no interference with the rear drain hose. Correct any abnormality if found.

1. Apply soapy water to the part of the sunroof frame where the rear drain hose is inserted.
2. Insert the rear drain hose end into the sunroof frame.
3. Install the rear drain hose to the clips parallel to the pillar and free of looseness.
4. Insert the rear drain hose grommet into the hole of the inner rear pillar.
5. Install the following parts:
1. Headliner
2. Assist handle
3. Sunvisor
4. Map light
5. C-pillar trim
6. Second-row seat belt upper anchor installation bolt
7. Trunk side trim
8. Cargo compartment light
9. Third-row seat belt lower anchor installation bolt
10. Rear header trim
11. Trunk end trim
12. Third-row seat
13. Sub-trunk
14. Rear package tray lid
15. B-pillar upper trim
16. Front seat belt upper anchor installation bolt
17. B-pillar lower trim
18. Rear scuff plate
19. Front scuff plate inner
20. A-pillar trim